Installing a Transmission Cooler
If you are like many people in the state, you’ll need a Utah auto repair center to install a transmission cooler for you. If, on the other hand, you have the tools, equipment, and a little expertise, you can install the transmission cooler yourself.
With the front end of the car raised securely, you will need to start by taking off the lower air dam at the base of the radiator. If you plumb the external cooler in series with the return line, you’ll probably get the best results. It beats the other options by about 5% efficiency, though it’s a little more difficult to work with.
In order to do this, you will need to tap into it at the transmission by running longer fluid lines back to the radiator. If this seems too labor intensive, you can settle for a little less cooling efficiency and plumb into the supply line instead.
Whichever lines you choose to work with, remove them and connect the fittings. Make sure to seal non-flare fittings to prevent leakage. Use the fasteners that come in the transmission cooler kit to mount the cooler to the front of the radiator.
Now, run the lines from the fittings to the cooler. Make sure that the lines are secure and are not hanging loosely or rubbing on any edges.
Once you are satisfied with the installation of the transmission cooler, you will need to replace the air dam. Because of the new lines, you may need to trim it down a bit to make room.
Now, turn on the engine and allow some pressure to build. Check the entire length the fluid flows for any leaks. If there are any, turn off the engine to repair those. If not, drive the car around for 10 minutes and check for leaks again. If there are no leaks, then you are finished installing your transmission cooler!Tags: utah auto repair
16 Jun, 2011